Features

• The transmission mechanism is provided with 2 main rails, 2 auxiliary rails and 16 equilibrium points as a whole kit.

• In the gap between the rails and the clamps there is a piece movable phosphor-bronze for enhanced friction resistance leading to stable trips.

• The foam tank and the pre-heater are adjstedsynchronously.
• The tin tank is retractable off the machine base for easycleaning and maintenance.
• The circuitry is controlled by S.C.R. for upgraded stabilityad energy-saving.
• The temperature control is conducted by the P.I.D. micro-computer for its zero-tolerance.

* Independent front ( rear ) rails with synchronized hydraulic cylinders for angle adjustment and
  precision shifts.
* Easy and fast change of width of the basilar plate producing no hydraucone.
* The wholly concealed bearings, shaft rods and the gearing keep oflife span.
* Three-set twin-temperature control, IR Pipe pre-heating forinstant temperature raise to meet the
  level demanded by the panel.
* Safety insulation glass for extended duration of the pre-heating piping.
* The pre-heating piping is removable independently for easymaintenance and service.
* The ball bearing, changeover tin nozzle meets perfectly the S.M.T.(chip) multi-ply board, single
  board as demanded by the perfect soldering.
* The changeover static wave peak changes the size and direction of the contact face of the nozzle
  according to the size of the basilar plate of the products.
* The rear auxiliary conveyor rail is available for the transfer of the unit, after welding the board so as
  to keep the clamps from being vulnerable to damages and deformation of the basilar plate while
  keeping the same from being subject to impacts.
* The powerful transverse cooling fan meets the demand of dissipation of the panel.